Hey folks. I've got this 036 Pro I would like to sell. I went through the saw from top to bottom. Top end has been freshened up with new rings, circlips, pin bearing, gasket, cyl. bolts and decompression valve. Crank bearings are original but have a lot of life left. Oil seals were replaced though. Crank itself is in damn good shape and also has a lot of life left. Ignition components are in great shape and spark plug is new. Starter works perfectly and is original. Chain brake components are also in great shape and work perfectly. Oiler has a new output line as the old one had been damaged. Clutch has new springs. The clutch needle bearing, drum, sprocket, washer and clip are all new. Clutch cover is good and has ms362 spikes with a new chain catcher. I put a kit in the carb and also installed a new fuel line, filter, tank vent valve and air filter. Unit has been pressure and vacuum tested and passed with flying colors. Fuel tank has also been vac. tested and carb pressure tested for leaks, no issues whatsoever.
Cylinder is mostly in stock form but I did polish the exhaust port and remove casting imperfections and smooth out the intake. Plastics on the saw are in fantastic shape, paint on the crankcase is also nice. There is some scuffing and paint loss on the bottom side of the case. Saw runs, cuts and oils like it should. It's in great shape for its age and I feel that whoever ends up with it will be very happy! It currently has a 20" rollomatic E bar with 3/8" full skip and full chisel chain. Pretty sure I have some full comp if it is desired. All parts are oem, no aftermarket. Asking $300 plus actual shipping. I ship safely, insured and only use UPS, or FedEx if requested. I will not use the postal service sorry. PayPal f&f or goods&services with an added 3%. If you think I'm pricing this too high then make an offer. Ask questions if ya got em.
Sent from my SM-N970U using Tapatalk
Cylinder is mostly in stock form but I did polish the exhaust port and remove casting imperfections and smooth out the intake. Plastics on the saw are in fantastic shape, paint on the crankcase is also nice. There is some scuffing and paint loss on the bottom side of the case. Saw runs, cuts and oils like it should. It's in great shape for its age and I feel that whoever ends up with it will be very happy! It currently has a 20" rollomatic E bar with 3/8" full skip and full chisel chain. Pretty sure I have some full comp if it is desired. All parts are oem, no aftermarket. Asking $300 plus actual shipping. I ship safely, insured and only use UPS, or FedEx if requested. I will not use the postal service sorry. PayPal f&f or goods&services with an added 3%. If you think I'm pricing this too high then make an offer. Ask questions if ya got em.
Sent from my SM-N970U using Tapatalk