Got my cases back from @glock37 and could not be more pleased. Started the build around 3:00 pm by first prepping the case halves.Then I heated each half up with heat gun and dropped the bearings in. Put the cases together and installed the p/c and the seals and pressure tested. Had a leak around the pto bushing so I took off and coated with grease and that solved that leak. Pressured it up and it leaked under the cylinder at where the cases joined together. I removed cylinder and cleaned the Dirko off and went back with high temp Perma-seal gasket maker and reset the cylinder. Let set about 40 minutes and pressured up and it held for 5 minutes. Did the same on vacum and it passed ! Installed the heat shield and put the oil pump and clutch assembly on and then installed the muffler. Been standing from 3:00 untill 9:15 and back was hurting so I called it quits for the night. More to follow with some pics.