Anyone have a related start situation?
Haven't counted but maybe six seven or eight pulls choke on but then it doesn't pop it actually runs and tgen slows as you might expect full choke, then on to half choke it picks up slowly bit by hit and then choke off and it runs ok, i think.
I have a cheapy compression tester but i think it doesnt seal right on the cylinder ecen though i epoxyed the rubber tube to the brass thing(ers) so with that saw and the 021 i get 25 psi. With the new farmertec/ holztformma 038 mag replica i get 50 psi.
Just wondering!
thanks
Haven't counted but maybe six seven or eight pulls choke on but then it doesn't pop it actually runs and tgen slows as you might expect full choke, then on to half choke it picks up slowly bit by hit and then choke off and it runs ok, i think.
I have a cheapy compression tester but i think it doesnt seal right on the cylinder ecen though i epoxyed the rubber tube to the brass thing(ers) so with that saw and the 021 i get 25 psi. With the new farmertec/ holztformma 038 mag replica i get 50 psi.
Just wondering!
thanks