yo2001
ArboristSite Operative
I notice that on 026 (I doubt it but could be just mine) the piston goes inset about 1.5mm lower than the lower part of exhaust port. Would that not be a place for an improvement? To me seems like it is a bad spot where end gas can trap and cause detonation problem when modded. On my 044, the piston stays above the bottom of the exhaust port. Any thought?
I'm still learning. So thanks for responding stupid question. If anyone can lead me to a good read that'll be great too. I have been looking through "2 stroke guide" some.
I'm still learning. So thanks for responding stupid question. If anyone can lead me to a good read that'll be great too. I have been looking through "2 stroke guide" some.