034 rim sprocket size

[bama]

I am putting an order together for some parts at Baileys and I want to be sure I get the right rim. I have a 7 tooth, 3/8 sprocket and it seems to be smaller than the small spline rims I have. I measured around 11/16, so is that the "mini" spline?

Replaces 0000 642 1231

 

[sloch24]

Call Baileys... They'll be more than happy to make sure you get the right part.

 

[bama]

Call Baileys... They'll be more than happy to make sure you get the right part.

I already did, but they are closed Saturdays. I was hoping to get this off today.

 

[willsaw4beer]

I think standard spline size is 7/8 (14/16) and small is 3/4 (12/16.) The mini is a Stihl exclusive I think? I don't know a whole lot about it, I haven't replaced a rim yet and I always get the same sprocket so I don't run into problems with the oiler or whatever else. It would be nice to have somebody that actually knows give a good rundown on this.

 

[Trigger-Time]

See PDF below

 

[bama]

See PDF below

Perfect! I do have the right one in the cart. It is the 13mm, but it is used by a homeowner so I am not worried about it. He ran it 15 years with no trouble. It would have still been ok if I hadn't broken it in removing it from the crankshaft. There was some kind of crap on the end of the shaft and as I pulled I squeezed and.......well, you can all figure out what happened to that plastic caged bearing!