etbrown4
ArboristSite Operative
I know this sounds unlikely so I'll cover the items checked so far on all 3 pieces of equipment:
Good Compression
Good fresh gas, oil mixed properly
Spark appears to be ok and blue
Spark plugs new
Plug when removed after pulling starter, is slightly moist
All 3 carbs thoroughly gone through and clean
L and H screws set at 1 3/4 out
Until running into these three units, I'd never seen a 2 cycle motor with good compression and a spark that would not fire on starting fluid, or a mist of gas/oil mixture. For me, it's sort of like....how is this even possible?
One of the three I finally got going with much adjusting to the L&H screws.
I'm stumped on the other two.
Suggestions welcome!
Good Compression
Good fresh gas, oil mixed properly
Spark appears to be ok and blue
Spark plugs new
Plug when removed after pulling starter, is slightly moist
All 3 carbs thoroughly gone through and clean
L and H screws set at 1 3/4 out
Until running into these three units, I'd never seen a 2 cycle motor with good compression and a spark that would not fire on starting fluid, or a mist of gas/oil mixture. For me, it's sort of like....how is this even possible?
One of the three I finally got going with much adjusting to the L&H screws.
I'm stumped on the other two.
Suggestions welcome!
Last edited: