verticaltrx
ArboristSite Member
I'm looking to set up my 361 to mill smaller cants of white pine and red oak (under 10", mostly 6") . I will be using a larger CSM on my 041 to make the cants, but I would like to set up the 361 with a good ripping chain for small cants (two saws on two CSM's to make the process faster/easier).
With that being said, I' probably going to outfit the 361 with the small mill, and .325 ripping chain on an 18" bar. From the research I have done on here it sounds like a good chain for this. First off, where can I find a .325 rim sprocket, bar, and the proper chain for my 361? (i.e. part numbers etc)
Or, would I just be better off with 3/8" LP ripping chain?
Any other advice? (aside from getting bigger saws lol )
With that being said, I' probably going to outfit the 361 with the small mill, and .325 ripping chain on an 18" bar. From the research I have done on here it sounds like a good chain for this. First off, where can I find a .325 rim sprocket, bar, and the proper chain for my 361? (i.e. part numbers etc)
Or, would I just be better off with 3/8" LP ripping chain?
Any other advice? (aside from getting bigger saws lol )