346xp top end kits

[Northerner]

Hi, so I’ve done quite a bit of research on this, but there’s so much info out there and a few variations of these saws.
So my question is, what’s the right kit to put on the 351/350 saws? Oem? Which is the good one,44.3? Supplier? Some of the flebay sellers can’t even tell me what dia bore the cylinder has that they have for sale...

 

[huskihl]

Here’s the Best Buy currently that I’ve found. 44.3 ne oem

https://www.google.com/shopping/pro...=eto:14283681944732239117_1,cdl:1,prmr:1,cs:1

 

[Northerner]

Here’s the Best Buy currently that I’ve found. 44.3 ne oem

https://www.google.com/shopping/pro...=eto:14283681944732239117_1,cdl:1,prmr:1,cs:1

Ok, that’s the seller that can’t tell me what bore it is. But I guess if it’s an oem kit the part number will tell me.
Have you purchased from there?

 

[huskihl]

Ok, that’s the seller that can’t tell me what bore it is. But I guess if it’s an oem kit the part number will tell me.
Have you purchased from there?

It’s 44.3. I’ve ordered 15-20 from them

 

[huskihl]

Ok, that’s the seller that can’t tell me what bore it is. But I guess if it’s an oem kit the part number will tell me.
Have you purchased from there?

They offer the same one on eBay for $20 more. I ordered one of them first before I got curious and went looking through Google and saw that it was cheaper on there

 

[huskihl]

I don’t believe the one in that link has the decomp drilled.

 

[cuinrearview]

I can confirm it's 44.3 and non-decomp

 

[9050lx]

Just put one of the OEM cylinders on a spare 350, Very impressive fast revving and broader powerband than I expected.

 

[huskihl]

Either use the base gasket or grind/file a trench for the impulse passage in the riser or cylinder extension

 

[cuinrearview]

base gasket

What's that?

 

[BigYoung]

tagged