The saw would die when given throttle. replaced pumper hose, checked gas line for breaks, disassembled carb to replace kit even though it looked OK. Fine sawdust in carb screen, couple of larger pieces in the pump side. Blew all that out with needles out. Did not remove plugs in carb body. Gasket looked good and same for the rubber intake, but did not take it off.
Wasn't much different after all this. Opened l and H about 1/3 turn and runs good and blubbers on high end while cutting. But I am suspicious it is varrying the mixture some, from rich to leaner. NOt sure though. Cut 2 28 inch pine logs while tuning it
Any ideas?.
Wasn't much different after all this. Opened l and H about 1/3 turn and runs good and blubbers on high end while cutting. But I am suspicious it is varrying the mixture some, from rich to leaner. NOt sure though. Cut 2 28 inch pine logs while tuning it
Any ideas?.