Yotaismygame
Juiced Saws #GetJuiced
Might want to double check those numbers. Personally I find using duration the most accurate or at least consistent way of measuring. An exhaust height of 90 is way up there. I've never ported a saw with that high of an exhaust. Any of the 372 cylinders Ive timed with a 268 040 pop up piston showed low 100s for exhaust after raising it, and transfers were all at 125. Good way to measure transfers is to stick a ring in the jug right at the transfer opening and then run the piston up to that point when measuring. Those transfers can be hard to see. Ill put a wheel on the jred I just posted and see what the exhaust height is at tonight.