I purchased a Rutland 6" polly brush to clean my new S/S flex liner. I tryed the brush on a section of leftover liner and found it to be VERY hard to force through the pipe. Is it suppose to be that difficult ? Dont want to damage the liner.... Any suggestions guys...
Cleaning Flex liner ?
- Thread starter KFC
- Start date
Help Support Arborist Forum:
Force it through.
I give mine a twist on the travel down to help. Just be sure to "tighten" with the twist so you don't lose your poles.
Once I bottom out, I just go up down several times, then move back up towards the top; repeat until the brush is back in hand and your face is covered in soot. WEAR A MASK! With a stove its pretty clean unless the wood isn't seasoned or you aren't burning hot. But when it is dirty, its nasty.
I give mine a twist on the travel down to help. Just be sure to "tighten" with the twist so you don't lose your poles.
Once I bottom out, I just go up down several times, then move back up towards the top; repeat until the brush is back in hand and your face is covered in soot. WEAR A MASK! With a stove its pretty clean unless the wood isn't seasoned or you aren't burning hot. But when it is dirty, its nasty.
Similar threads
