Sold Disston DA211 piston

[cbfarmall]

Back to needing a good piston for another 211 project, my KA-211. Seems the front cylinders don't hold up very well on these saws. Anyway, I could use a good piston to replace my scored up one. Prefer with the rod attached so I don't have to mess with the wrist pin but I'll take what I can get.

PM with info.

Thanks, Chris B.

A 211 piston pictured.

 

[Bill G]

I wish you needed KB ones.

 

[cbfarmall]

Nope. Those seem not to be as problematic as 211 pistons. Probably because KBs are most all governed.

 

[Bill G]

Years ago I was dealing with a gentleman that was taking the DA211 and putting AH58 jugs .pistons on them. He also did some wicked stuff with the KB7 such as two big carbs. They were an entire different engine at that point. Sadly I believe he has passed away.

 

[Lightning Performance]

Try looking by size in the Weisco or OMC crossflow boat outboard engine pistons. You might find something there.
Is your wrist pin size metric or other?

 

[cbfarmall]

Standard pin I've no doubt. 1/2" is my guess.

 

[Lightning Performance]

Standard pin I've no doubt. 1/2" is my guess.

Check the Napa Marine catalog division

 

[cbfarmall]

I'll try. Thanks.

 

[cbfarmall]

Piston found and acquired.