Dual headed Chainsaw Mill

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

PhilB

ArboristSite Operative
Joined
Dec 26, 2010
Messages
112
Reaction score
58
Location
Illinois
This is a video of my homebuilt dual headed chainsaw mill

[video=youtube;jhHPQAgm6j4]http://www.youtube.com/watch?v=jhHPQAgm6j4&feature=plcp[/video]

The power heads are Makita 6401's with 84 cc Big bore kits and opened up mufflers. This is the first time I have used a chainsaw mill and all went better than expected. My friend Jeremy is at the controls and I'm the helper.

Features of the Mill are: guide shoes that ride on the ladder rails, dual remote throttles with a magnetic latch in the full on position, and a winch with an adjustable elevation.

I'll be posting pictures of the details as time permits (probably next weekend).

Phil
 
Last edited:
Nice set-up,

ripping is not an easy thing to put a (two) saws through.

You need to post some pics of the cut.
 
Hamish,

Once the saws come up to speed, the clutches are locked and both power heads run at the same speed. I experienced no problems running two power heads. With one clutch slipping I would expect to hear a beat note (one power head running at a different speed than the other).

Phil
 
Sweet setup. I like all the thought you put into the stuff most don't. I think that's why CSM's have such a bad rep. Your throttle and winch system is nice. Keep the wideo comming!
 
Phil,

Have you tached both saws in the cut? Thank god for clutches! Just got to pondering wear items with two powerheads used in line. Something new for me to figure out and maybe try one day.

What chain set up are you running?
 
Nice job!

At about the 4 minute mark of the vid I see the power heads jumping around a little. What does this do to the cut finish?

One to remove/reduce the bounce might be to the mounting the mill to the power head via the bar bolts rather than the bar itself.

Anyway, looking forward to some closeups of the mill.


Cheers
 
Nice job!

At about the 4 minute mark of the vid I see the power heads jumping around a little. What does this do to the cut finish?

One to remove/reduce the bounce might be to the mounting the mill to the power head via the bar bolts rather than the bar itself

Anyway, looking forward to some closeups of the mill.


Cheers

The jumping didn't effect the finish. The finish is very smooth with no ripples or any other marks.
I'm considering modifying the power head connection as you suggested. I should be able to do this with very little modification.

I've been reading your post's and others trying to design an efficient CSM. I've got a lot of pro's and con's from those posts.
 
You need to post some pics of the cut.

full size image

attachment.php


closeup image

attachment.php
 
The jumping didn't effect the finish. The finish is very smooth with no ripples or any other marks.
Good to hear. Now that I see your cut I wonder if it was just cutting through one of those knots at that point it was jumping?

I'm considering modifying the power head connection as you suggested. I should be able to do this with very little modification.
Keeping the mill and saw rigid helps reduce wear and tear over the long haul so I reckon it's worth it.

I've been reading your post's and others trying to design an efficient CSM. I've got a lot of pro's and con's from those posts.
Yep there sure is a heap of useful info in this forum.

With two power heads and a total of 172 cc you should experiment with dropping the rakers. I'd try an raker-cutter-wood angle of about 7º and go up from there.

Cheers
 
Back
Top