While visiting family today I saw a dust covered 044 in the garage and asked why it wasn't being used. Was told the crank was shot and that I could have the saw if I wanted it. After peeking in the exhaust port, I see it will need a new piston and cylinder along with the crank, bearings, gaskets, etc.
After some research online I find out there's either a 10mm or 12mm wrist pin. The serial number is 119402254 - any help determining the pin size would be appreciated.
I can get new aftermarket parts off ebay for ~$270-300 total.
Is this worth diving into? What problems will I most likely run into?
Thanks everyone.
After some research online I find out there's either a 10mm or 12mm wrist pin. The serial number is 119402254 - any help determining the pin size would be appreciated.
I can get new aftermarket parts off ebay for ~$270-300 total.
Is this worth diving into? What problems will I most likely run into?
Thanks everyone.