Jim S.
ArboristSite Lurker
I recently acquired several hundred bdf of red oak that was bandsaw milled a few years ago. In it are a number of boards that have been infested with worms which I think are still active. Holes (slightly less than 1/16" dia) are visible on some surfaces and frass is beneath most of the holes. I have not yet sawn any to see how extensive the tunneling is.
Are there any ways of killing the active infestation short of commercially heating above a specified temp? I am looking for a solution that I can implement myself. I don't have or know of a local kiln for heating.
I have contemplated building an airtight box (probably lined with heavy plastic) and putting the infested wood in it after spraying or brushing on an appropriate pesticide. My presumption is that with a bit of "soaking" time (weeks or months), the pesticide would kill the active bugs. After exposure, I also presume the active ingredients of the pesticide would be in low enough concentrations to pose no health problems.
Has anyone tried this or can suggest another effective technique?
My plan for the wood is for structural parts of cabinets and other millwork where the surface holes or tunneling is not detrimental.
If this is not the best thread for this question, please redirect me.
Regards,
Jim
Are there any ways of killing the active infestation short of commercially heating above a specified temp? I am looking for a solution that I can implement myself. I don't have or know of a local kiln for heating.
I have contemplated building an airtight box (probably lined with heavy plastic) and putting the infested wood in it after spraying or brushing on an appropriate pesticide. My presumption is that with a bit of "soaking" time (weeks or months), the pesticide would kill the active bugs. After exposure, I also presume the active ingredients of the pesticide would be in low enough concentrations to pose no health problems.
Has anyone tried this or can suggest another effective technique?
My plan for the wood is for structural parts of cabinets and other millwork where the surface holes or tunneling is not detrimental.
If this is not the best thread for this question, please redirect me.
Regards,
Jim