Outdoorguy1979
ArboristSite Operative
so I picked up a Husqvarna 61 with a black top a few days ago. the saw was real dirty and nasty, so I did a compression test with 120 psi but did not fill right. I tore the saw apart and saw some scoring on the cylinder and piston.
so here is my question
I'm planning on rebuilding this saw, and was wondering does anyone have any recommendations on a cylinder kit? I found one by hyway but don't know how good they are?
also my 2nd question since I'm replacing the cylinder and piston how good are the big bore kits? do they need modifications as some posts say they do and some don't? or should I just replace the cylinder with a used oem ?
and one last question if I do a big bore swap how big of a bar can i put on the saw? thanks for the input in advance
so here is my question
I'm planning on rebuilding this saw, and was wondering does anyone have any recommendations on a cylinder kit? I found one by hyway but don't know how good they are?
also my 2nd question since I'm replacing the cylinder and piston how good are the big bore kits? do they need modifications as some posts say they do and some don't? or should I just replace the cylinder with a used oem ?
and one last question if I do a big bore swap how big of a bar can i put on the saw? thanks for the input in advance