Husqvarna 350 and 346 aftermarket cylinder kits? which one's the best?

[forex82]

So right, so right......but did'n see that before they broke...

 

[SawTroll]

So right, so right......but did'n see that before they broke...

Sorry, but the evidence is overwhelming, lots of reports on that! :msp_wink:

 

[Mtnyota]

So is the consensus that the Kafar85 kits are a good alternative to the Pricey OEM Piston and cylinder for a NE346xp?

346XP 350 353 chainsaw cylinder & Piston kit fits Husqvarna (44.1mm) | eBay

Baileys is only listing the 42mm pistons & kits online right now

 

[3GGG]

Looking at the kafar85 kit also, anyone using this with any luck. Got quoted $465 plus gst for oem.

 

[ncfarmboy]

So is the consensus that the Kafar85 kits are a good alternative to the Pricey OEM Piston and cylinder for a NE346xp?

346XP 350 353 chainsaw cylinder & Piston kit fits Husqvarna (44.1mm) | eBay

Baileys is only listing the 42mm pistons & kits online right now

The one I ported for the Pro carver must be holding up OK haven't heard from him. It's been over a year. Shep

 

[bjorn773]

Here are some pics of the kafar kit. I have used this saw very little due to an idling issue, but when it runs it screams. Also, the p/c were not installed until significant mods were done to them. Expect to do a lot of grinding as the pics show.

http://www.arboristsite.com/chainsaw/114159-5.htm

 

[bushleague]

Cylinder kits:

Here are some pics of the kafar kit. I have used this saw very little due to an idling issue, but when it runs it screams. Also, the p/c were not installed until significant mods were done to them. Expect to do a lot of grinding as the pics show.

http://www.arboristsite.com/chainsaw/114159-5.htm

Can we mount the Husqvarna 50/51 (46MM) kit on the 350 case?