Looking for crank seals for a 44, anybody know what fits? None of the sites seem to have the oem. Thanks
Husqvarna 44
- Thread starter kz1000
- Start date
Help Support Arborist Forum:
Huskitoter
ArboristSite Operative
This is my goto site for part numbers....
https://www.partstree.com/parts/husqvarna/saws-chainsaw/?pageNumber=1
Guess that doesn't help if the parts show not available. Somebody on here knows.
Deleted bearing info.
https://www.partstree.com/parts/husqvarna/saws-chainsaw/?pageNumber=1
Guess that doesn't help if the parts show not available. Somebody on here knows.
Deleted bearing info.
There's a mistake on that page. The correct number for the clutch side bearing is 50 15 940-01, not -00.
Obtaining the seal might still be difficult.
Huskitoter
ArboristSite Operative
Deleted. Looked at bearings instead of seals.
May not help but I'm pretty sure 133 & 242 use the same seals.
I haven't pulled them yet so don't have any figures. Been fighting the carburetor and think they may be why. Guess I'll vac it to be sure. Thanks.
I have 44 that starts and idles real well but won't rev for S**t it's a HDA carb. Will try soaking in Sea Foam
This one has the hdc and it really wanted to flood bad. I sonic cleaned it and put in a kit but found that the diaphragm had a longer center point, filed it down and it's a whole lot better. Floods on it's side and the l and h are out more than they should be.
I have a hda144a but the primer hole is in a different location.
Huskitoter
ArboristSite Operative
Sounds like an AM kit. Plenty of those just don't work right, including the one I received where the metal disc was on the wrong side of the diapram.
