TFPace
ArboristSite Operative
My trusty '13 550XP is cutting out. It acts like the switch is being turned off when the saw is in a cut wide-open.
I took it in to the dealer and he hooked it up to the computer and we updated everything.
The coil number was entered into the program, etc. I stood beside the tech and he showed me all the bells and whistles, etc .Run time...
It has a new fuel filter, plug , etc.
Anyway, after all of this it's doing the same thing.
The saw had to get hot and then it started acting up.
After the tech did his stuff at the shop it ran fine. Of course it messed up after I brought it back to the woods.
This saw has given no problems since day one. I love it.
Thank goodness for the 257 and 345.
Ideas?
The tech said that a carb would be next. I would have thought the computer would tell if the carb was bad.
Advice and guidance is appreciated.
Tom
I took it in to the dealer and he hooked it up to the computer and we updated everything.
The coil number was entered into the program, etc. I stood beside the tech and he showed me all the bells and whistles, etc .Run time...
It has a new fuel filter, plug , etc.
Anyway, after all of this it's doing the same thing.
The saw had to get hot and then it started acting up.
After the tech did his stuff at the shop it ran fine. Of course it messed up after I brought it back to the woods.
This saw has given no problems since day one. I love it.
Thank goodness for the 257 and 345.
Ideas?
The tech said that a carb would be next. I would have thought the computer would tell if the carb was bad.
Advice and guidance is appreciated.
Tom