The oil feed holes in my Husqvarna bars seem pretty darn small. Has anybody drilled out their bars to enlarge the oil feed holes and had good success? If so, have you noticed any difference in bar/chain lubrication? Tips/suggestions?
JQ
JQ
The oil feed holes in my Husqvarna bars seem pretty darn small. Has anybody drilled out their bars to enlarge the oil feed holes and had good success? If so, have you noticed any difference in bar/chain lubrication? Tips/suggestions?
JQ
The oil feed holes in my Husqvarna bars seem pretty darn small. Has anybody drilled out their bars to enlarge the oil feed holes and had good success? If so, have you noticed any difference in bar/chain lubrication? Tips/suggestions?
JQ
The oiler is adjustable on all but the lower end of Husky line up. I have only had issue with one saw all the rest were set fine out of the box, and that one saw wouldnt you know is non-adjustable go figure. Which saw do you have?
Kansas
Enter your email address to join: