Just picked up a Jonsered 630 super11 project saw, all looks good, needs a good clean, compression is a phenominal 200psi without any work, clutch bearing is shot but that seems to be the only nasty bit so far. Bit of a bargain at £29 or around $45.
Now the question - where should the fuel tank breather be routed, currently it runs up the handle as in the photo and has a cable tie holding it in place but it doesn't look standard fitment to me.
If anyone else out there has one, can you post a photo of the correct path of the breather or is this correct?
That makes 9 petrol saws and one electric - oh, and one in bits - who said CAD - no such thing!!:chainsawguy:
Now the question - where should the fuel tank breather be routed, currently it runs up the handle as in the photo and has a cable tie holding it in place but it doesn't look standard fitment to me.
If anyone else out there has one, can you post a photo of the correct path of the breather or is this correct?
That makes 9 petrol saws and one electric - oh, and one in bits - who said CAD - no such thing!!:chainsawguy: