I think the notch in the metering lever tool is because the lever is notched and not round. Might be something to do with that.Dynamic balancing cut out to make up for metal removed at punched hole and tit at right hand side--for sure-David
You are referring to the little notch right below the SDC, right?Hi guys,
I have Walbro WS carb and I am setting metering lever height, however I don’t understand why this V-notch is there (Below the WS and SDC) ? All the other carbs I have done have all been the height of the sides of the carb.
Any advice and direction is much appreciatedView attachment 836436
YesYou are referring to the little notch right below the SDC, right?
Enter your email address to join: