MS361 - Can barely pull w/plug - possibilities???

[neely]

You can do a nice job of plastic welding that cover using an electric soldering iron Idve done a couple if them now
drive the hot point into and along the crack as you drag the iron along it will produce two wind rowes of multon plastic , use the iron to push these back into the trench and smooth over makes a good fix
If you can find a same type of plastic to use as a filler rod you can maybe do a better stronger well ;O)

i use coffee stir straws to melt into cracks the red ones are thicker and work real well

 

[angelo c]

Id take a close look at the crank on that puppy fer I wer you ?
that's a heck of a load to clean break a cyl with downward force unless there was some side ways torque.
Maybe it took a flying lesson from a bucket truck or climber? those silly bastiges think anything with a motor on it is safe to fly ....

 

[Red Amor]

i use coffee stir straws to melt into cracks the red ones are thicker and work real well

arrrrrighto ill keep a look out for some ;O)

 

[krushing73]

My generator did same thing after sitting up. The cylinder was completely flooded. Blow Into cylinder lightly and steady with an air compressor.