Heres what I'm working with:
Fixed up this saw and had it running great. Couldn't tune it to stop chain at idle because I found clutch spring was broken.
New clutch in.
Now the saw just starts and dies. If I feather the throttle a little it will start alive. If I go WOT it dies. If I give it no throttle it dies. Sometimes it floods itself.
Originally I took the saw apart, replaced fuel lines, rebuilt and cleaned carb, bought a new carb to fiddle, visually inspected intake boot and impulse line.
Checked my seals by the turning it over method, and sprayed carb cleaned at the seals for good measure.
Only other things I can think of is putting the clutch in I lazily broke a flywheel fin, and that the saw has 2 drilled ports in the front of muffler.
Any help appreciates. I do not want to give up fixing this particular saw.
Fixed up this saw and had it running great. Couldn't tune it to stop chain at idle because I found clutch spring was broken.
New clutch in.
Now the saw just starts and dies. If I feather the throttle a little it will start alive. If I go WOT it dies. If I give it no throttle it dies. Sometimes it floods itself.
Originally I took the saw apart, replaced fuel lines, rebuilt and cleaned carb, bought a new carb to fiddle, visually inspected intake boot and impulse line.
Checked my seals by the turning it over method, and sprayed carb cleaned at the seals for good measure.
Only other things I can think of is putting the clutch in I lazily broke a flywheel fin, and that the saw has 2 drilled ports in the front of muffler.
Any help appreciates. I do not want to give up fixing this particular saw.