I got this in a pile of saws that didn't run for very cheap. Sold everything except for this one. rebuilt the car and it runs! It's been sitting unused on a shelf. Today I decided to put a bar on it, and give it a try. Filled up the oil tank, got ti to start, let it run for a minute, and realized I had put a LARGE pool of bar oil on the shop floor. Appears ro be coming out from the bottom front are of the saw. In the picture is a somewhat hidden small hole that I'm guessing is some kind of oil supply line, Have vert little experience with oilers. Hoping I don't have to tear the saw apart, but it seems like I may have to remove both the full wrap and the tank handle to access that area? Was hoping to avoid that..... Any idea what happened? At least it looks pretty! That hole is right underneath where handle attaches to bottom of saw.