need 090 experts 090 flywheel 1106 400 1202 aftermarket one too tall-help

[cscltd]

hey all
looking for 090 experts on flywheel help,
had 090 come in with bad flywheel-center spun,
ordered replacement aftermarket (new nla) like this one-says it is 1106 400 1202 (it is not the 070 11064001206 smaller dia version) after market on top, original on bottom-
the dia is correct and fits on shaft ok, but the riveted section were thread puller goes in is about .25 inch higher than old one, hence when starter cup goes on it does not allow starter housing to sit flush on crankcase and also starter cup binds against starter pully, any suggestions or anyone came across this issue?
or anyone have a one for sale-i know ebay has one for $160us plus shipping-close to $300. for me once landed as customs will take a bite with fees and taxes
thanks

 

[Zero_sum]

Yup....I had the same problem a couple of years. I ended up re-using the OE flywheel with some sleeve retainer & sent it (no love left for that saw lol). I'm not sure if there are multiple OE flywheels available, or if the 10 year old kid that made the Chinese version I had just had a bad day LOL.