older oregon bar

[woodbine]

Found an new/old stock Oregon bar for sale, but seller doesn't know guage or fit other than it's 3/8 pitch and 23" total length. It has the following code on bar/packaging 7763 FX 208-H009 anyone have any idea what it might fit?

 

[gatkeper1]

20", 3/8, .058" 72DL. It is a Husky large mount bar same as a D009

 

[woodbine]

Thanks Greg your input is very much appreciated!





Rich

 

[SawTroll]

Yep - well can't confirm the 72dl, but most likely, yes.....

 

[Dibbs]

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=320167786916

I was having a look at this auction too Woodbine, I was intending to file out the bar mount slot to make it fit my MS440.
Might see you in the dying seconds if the auction with the other "Snipers"! :sword:

 

[woodbine]

Hope not!:bang:

 

[SawTroll]

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=320167786916

I was having a look at this auction too Woodbine, I was intending to file out the bar mount slot to make it fit my MS440.
Might see you in the dying seconds if the auction with the other "Snipers"! :sword:

That will be a lot of filing, I wouldn't care to do that........:

 

[Dibbs]

That will be a lot of filing, I wouldn't care to do that........:

Well the small angle grinder to take out the most if it does help then use the files for finishing off.

Already done this with a 26" Oregon bar (Husqvarna Mount) and it worked a treat.
Good 26" bar and a never sharpened 26" chain for £27 ($54 USD) couldn't be bad! (not in the UK anyway)
I even enjoyed the 1/2 hour I spent to make it fit my MS440 Stihl!
I think you apreciate something more when you have put effort into making it work.