This is one I can't figure out.
Got a Powerstroke 3000 PSI 2.5 GPM Pressure Washer with a Powerstroke 212cc OHV engine.
It is almost new and never ran much, let it setup for about a year. It ran fine when last used, got it out to use and it won't crank.
Cleaned the gas tank, new spark plug, took carb off and did a deep cleaning, gas going to carb, still won't crank, check spark plug and it's dry even with choke on.
Take spark plug out put gas in cylinder head and it cranks then goes dead.
Put new carb on, new coil, check engine breather cover to make sure it's clear, open gas tank cap, compression good, still won't crank, take spark plug out put gas in cylinder head and it cranks then goes dead.
The only thing I haven't done is pull the muffler and check for a restriction.
Any ideas on how to solve this.
Got a Powerstroke 3000 PSI 2.5 GPM Pressure Washer with a Powerstroke 212cc OHV engine.
It is almost new and never ran much, let it setup for about a year. It ran fine when last used, got it out to use and it won't crank.
Cleaned the gas tank, new spark plug, took carb off and did a deep cleaning, gas going to carb, still won't crank, check spark plug and it's dry even with choke on.
Take spark plug out put gas in cylinder head and it cranks then goes dead.
Put new carb on, new coil, check engine breather cover to make sure it's clear, open gas tank cap, compression good, still won't crank, take spark plug out put gas in cylinder head and it cranks then goes dead.
The only thing I haven't done is pull the muffler and check for a restriction.
Any ideas on how to solve this.