Wondering if anyone knows where to wire in an electronic module to replace points on an old Jonsered 80? The saw has a primary and seconday coil (winding). All of the Youtube videos are of wiring in the module with a single coil. The 80 has a winding beneath the flywheel (primary or secondary?) and a coil that sits under the main cover. The coil under the top cover does not interact directly with the flywheel so I assume the winding under the flywheel generates the initial voltage? The coil under the cover connects via wire to the points/condenser/winding under the flywheel and then runs to the plug. Maybe it is not even possible on this set up? Can include pictures if anyone is willing to consult.
Thank you.
Thank you.