BIG JAKE
Let’s go Brandon!
I had two powerheads suitable to drive the Ripsaw. I wanted to use the 028 for the purpose but figured I'd try 'em both and then make the decision. So I cut about 100 board feet of pine yesterday. More of a test to decide which powerhead to use on the mill than maximized lumber output as I'm still getting my ducks in a row in learning how to use this thing. I used the 039 first. It had more than enough power and I was giddy zipping of planks with the combination. Judging by that performance I figured the 028 would fit the bill so I swapped powerheads. Tried a few cuts. I'll put it this way-I wouldn't be happy with the Ripsaw performance with the 028 and disappointed if I'd just outlayed the money for that combination. Manufacturer states that this powerhead will work. Actually, it's more of the characteristics of the way the 028(points/magneto) runs that I don't like, as compared to the 039, which has instant throttle response. The 028 does have enough power, but what a difference. So the 039 gets the nod.