I have a Silvey model 300 sharpener that I use for chisel, semi-chisel and chipper chain and it always seemed to work well until just recently. I seem to have one cutter being ground more than the other which is abviously causing me some trouble. I e-mailed Silvey and the gal said I needed to shim the chain bar. Before I screw everthing up, has anyone had a problem like this? Howd ya fix it?
Silvey Model 300
- Thread starter abohac
- Start date
Help Support Arborist Forum:
call Silvey back up again... and request a owners manual. purchased two grinder disc (5 3/34" x 1in arbor), Silvey included manual for free.
folks at Silvey were very knowledgeable and helpful.
loads of details on proper setup for Silvey Model 300 inside.
serial number is stamped on base of grinder.
folks at Silvey were very knowledgeable and helpful.
loads of details on proper setup for Silvey Model 300 inside.
serial number is stamped on base of grinder.
