Stihl Ms250 Wiring Help

[hometheaterman]

I took this saw apart probably close to a year ago and forgot about it. Now that I finally have time to put it back together I'm realizing I don't remember where this wire goes. So there is one wire connected to the bolt that holds the coil in. I'm pretty sure this goes to the ground screw on the block. However, there is another one in that area. It comes from the wire harness that runs to the switch. The other end of this wire is the plug at the switch end. I've attached a picture. Does anyone know where it goes?

 

[KostasVolos]

Both the yellow/green wires with the loop ends should be attached together to the engine .
The one attached to the coil's armature is the "ground" / "case"
and has to be connected with the engine block .The other one is the ground which is used to shut off the engine.That also has to be attached to the same engine spot .

 

[hometheaterman]

Both the yellow/green wires with the loop ends should be attached together to the engine .

Thank you! I finally found a picture of when I took it apart and you are correct. It looks like they both go to the ground on the engine. Thank you!

 

[a. palmer jr.]

Yeah, part of the kill switch circuit.