They gotta wear big hats?????
Sure is quiet in here....do I need to start a fight?
- Thread starter caleath
- Start date
Help Support Arborist Forum:
They gotta wear big hats?????
Yep & nope on the ears thing ? Must be before my time. LOL
Mighty Mouse is a souped up version of Mickey Mouse!
Yup bigger ears and a real big stick 
Yup bigger ears and a real big stick
You mean schtick........
stihl023/5
Addicted to ArboristSite
Oh my.Yup bigger ears and a real big stick
I gots to call Stihlcrazy and thank him for the ms241 recomdation, awesome Swiss army knife of a saw
Mighty Mouse Logging LLC
Mighty Mouse Logging LLC
So.............a while back I posted a few pics of a 2095 milling saw that came into the shop.....it is a 1997 saw. By my best judgements it might have 15 hrs on it total.....it is totally new............gonna do a pressure/vac test, rebuild the carb, pressure and vac test the fuel line.......just in a go through.. Very sweet saw!!! More tomorrow!!!
Kewl!!!!!
Sounds like a real nice saw !
I did a little port grinding on a sweet 2094 I had here before I sent it off to Hawaii , it was a strong saw stock and after porting it became a very serious cutting machine. Last I heard it had broken two different .404 chains just pulling them through very hard island wood. The 2095 was supposedly a great milling chainsaw but I never had one here to compare with the 2094.
It is......real nice.....all back together tuned and ready to go home ......pics will be up in a bit....here she is again as it arrived...non running...19 years old with about 10 to 15 hrs on it.....very little use..... original B&C.......20" .325 X 0.050 Spur sprocket just barely shows any wear at all.....
These first few pics are of parts just as they were removed from the saw.....not even air hosed.....you ever seen such a clean carb bore?? I meen that was near 20 yrs old...and how about that air filter?? Turbo filtration system was doing it's job....
I took this thing down as far as I needed to......piston looked perfect of course.....everything looked perfect really.....cleaned everything as I put it back together. It passed a vac and pressure test with flying colors.....impulse and fuel line got pressure and vac tested as well.......everything was great..... threw the carb body in the UC for a time and then installed a new carb kit....other than the screw that held the spark screen in the carb kit was the only new parts used....
I remember that saw......the new owner made some very nice things with that saw!!
I was truly amazed when I discovered this one, that came on a Jonsered saw mill, came outfitted in .325....????? I doubt you could buy another spur sprocket for it in .325.....???? The rip chain was so freeking dull you couldn't cut your finger with it........the back of the tooth was sharper than the front!!! This one runs/sounds very strong......gonna do a comp test in the morning.....
Almost there!!!!
As far as I know Jeff still has that saw and still uses it for ripping or milling chunks of that hard island wood. I have not seen any posts from him lately.
Very nice saw !!!
