Timberframed
ArboristSite Guru
Thinking about an 87" bar and fitting two Oly Mac 999's on it. Pros and cons? Does it make that much a difference?
So is it worth it. Do you have any timed runs with one powerhead verses two?No.
Phil
I've just have the two power head mill. I milled a 32" width (average) by 10' long red oak in slightly over 4 minutes. I have planed to make a one power head mill but other projects and obligations keep getting in the way.So is it worth it. Do you have any timed runs with one powerhead verses two?
I use it just for milling.Phil, do you use the twin motor set to cut the trees into lengths, ie the 10 ft one above or to do any felling.
Just a word of caution about using a hard/metal contact direct onto a CS trigger for a remote throttle like this. Over time the vibe will wear the plastic trigger away, and although they are relatively cheap to replace, this can be avoided by using a softer material between the two.
No the mufflers face each other. Point two saws at each other in that form and see how the pulling side of one saw is the "pushing side of the other.One has to be upside down ?
Enter your email address to join: