Boogedy_Man
ArboristSite Operative
Ok, so I'm at 36" now running a MS661 in a Granberg MkIII (now with 48" rails for a full 36" cut with 50" cannon bar).
That has the saw about tapped out, and in truth, it's probably a bit much in hardwoods. The 48" rails are nice though, much heavier than the smaller Granberg mills.
How big can a single MS880 go before enough is enough? Or a better way to put it, if I wanted a 60" cut capacity for hardwoods what would I need in terms of powerhead(s)?
Let's see your big-arse chainsaw mills!
That has the saw about tapped out, and in truth, it's probably a bit much in hardwoods. The 48" rails are nice though, much heavier than the smaller Granberg mills.
How big can a single MS880 go before enough is enough? Or a better way to put it, if I wanted a 60" cut capacity for hardwoods what would I need in terms of powerhead(s)?
Let's see your big-arse chainsaw mills!