Search results

Yes, when I plug the spark plug in, ground it and pull the cord, there is consistent spark every time. I'll probably give it a couple tries and then call around to figure out where to send it to get a dealer with the right equipment to try to fix it. When it runs it runs so good, but I'd settle...

Thanks, I'm 100% positive its got the same mix gas in it as the day before when it ran normally. The same gas (92 octane non ethanol, 50:1 husqvarna synthetic oil) has been running great in several other saws and is all the 550xp has ever run on. The saw appears to be flooding, the plug is real...

Hi everyone, It's been awhile since I have posted. I have a 2016 vintage 550xp that has always run ok since I got it in 2017. Ok means I can always get it started, sometimes one pull, sometimes 10. It often dies at idle, and often dies if you begin to give it throttle and then let off. But it...

I got my chains, very well packaged, and very quick as always. Thanks again

Thanks for another quick, well packaged order!

Hello, I finally got some saws out & cutting. Tested, were an oregon pro-lite 20" .050 gauge .325 pitch bar using Oregon 95TXL, a Tsumura 375ZR2 18" .058 gauge .325" gauge bar using Oregon 21BPX, and an Oregon Powermatch 36" .063 gauge 3/8 bar using woodland pro (carlton) 33SC semi chisel. All...

Thanks for the replies everyone! in the near future Ill compare a 325 NK, probably 95TXL, to 20LPX, both new chains on a new bar. I'll do my best to get good measurements of kerf width.

Thanks for the quick shipping, the chains look great!

Hello, I am new here, but have been scouring the archives for information. I am very interested in narrow kerf .325 chain. I understand that the actual kerf is variable. I am surprised that I can find no references to actual bar thicknesses. I just measured two new standard .325 bars, my oregon...