Latest activity
Help Support Arborist Forum:
-
PPhilbert replied to the thread Chain Vice Comparison - Oregon 520-120 vs Oregon 511AX.Chain Grinder Centering Most full-sized chain grinders have some way to center the grinding wheel. But this changes as the wheel wears...
-
-
Kodiak Kid replied to the thread Scrounging Firewood (and other stuff).🤔Is there any other way?🤷 -
Kodiak Kid reacted to Squareground3691's post in the thread Scrounging Firewood (and other stuff) with
Haha.
Looks overloaded,Lol 👍😆 -
Kodiak Kid replied to the thread Scrounging Firewood (and other stuff).No
-
Kodiak Kid reacted to Squareground3691's post in the thread Scrounging Firewood (and other stuff) with Like.
You need any permit, to harvest the wood , ?
-
L34 replied to the thread Want to Buy early stihl 064 coil #2-204-222-108 new or used working good condition.This is where my fly wheel is timed at TDC. Running no key and universal coil -
-
ray benson replied to the thread Air Gap Stihl MS 311..2mm to .3mm Check your inbox for a service manual and ipl. Page 6 in the service manual has the coil air gap spec. -
L34 reacted to Mad Professor's post in the thread Want to Buy early stihl 064 coil #2-204-222-108 new or used working good condition with Like.
Early 064 coils/cases had different bolt pattern. Some with 2 some with 3 bolt holes. Some 046 coils will fit.
-
L34 reacted to Mad Professor's post in the thread Want to Buy early stihl 064 coil #2-204-222-108 new or used working good condition with Like.
If an early case you can make an adapter. Run universal coil Our friend from down under did. Photos credited to him, @L34.
-
MustangMike reacted to MechanicMatt's post in the thread Scrounging Firewood (and other stuff) with Like.
Can you guys see this? Wonder if I could slap some together for up at camp -
SI would like to know the air gap between the flywheel magnets and the ignition coil for a Stihl MS 311 chainsaw. Thank you.
-
MustangMike reacted to chipper1's post in the thread Scrounging Firewood (and other stuff) with Like.
Ran quite a few tanks thru the little beast(the ms200) recently, and a few in the ms261. I need to get the 550's out and let them...
-
MustangMike reacted to chipper1's post in the thread Scrounging Firewood (and other stuff) with Like.
I couldn't even tell those were chips, gonna need a good pic of the cutters lol. It works great on saws for bar oil, and many other...
-
MustangMike reacted to H-Ranch's post in the thread Scrounging Firewood (and other stuff) with Like.
Sell? That's a great idea! And here I was just gonna give it to you. ;)
-
MustangMike reacted to H-Ranch's post in the thread Scrounging Firewood (and other stuff) with Like.
It's a bender for mild steel stock. Different dies for shapes and sizes. Sometimes used for gate/fence scroll work but can be used for...
