Search results

replacing door seal on the shaver has anyone replaced the door seal on the shaver with the rope type or is the silcone a better seal.

spare parts just curious, what, if any spare parts do you keep on hand for that time when something fails. for me i depend on my shaver a good bit, so stocking a spare pump,blower,and a spare ranco theromostat gives me some piece of mind. in my area none of this is stocked in stores so it will...

if he lives in ohio the land owner is protected from such a lawsuite. i know if i give someone permission to hunt on my land, and something bad happens like he gets hurt , i am not liable.

in Ben's reply to me was that they were doing this to there new units shipped. he did not state what type they were using. in my door i just packed ( i think it is rock wool ) in the space , no problems falling out. i would think regular pink might work. jim

i just recieved e-mail from ben shaver about this, and his reply was , they are doing this on there new units.

door insulation has anyone that has insulated between the door and inner plate develop any problems arising from adding it. just wondering.

it came down between the Mahoning and Shaver. to me and the research i did i went with the shaver 165. i can say i am very satisfied, an i know a fellow with a Mahoning and he is quite happy also. the way the Shaver is built attracted me.

do your pumps run 24/7? is your blower getting enough air for a quicker recovery rate? how much lift do you have.

is melting a little snow that big of a problem? what is the acceptable heat loss. i would think if they were buried 4ft.down there should be no noticeable snow melt, but bury the same line 2ft. down you probably will see snow melt. i melt some snow when it warms up, my lines are buried 2 ft.down...

even with the flap shut tightely closed you are still sucking air in through the motor end, so you'll always have some air getting to the fire. has anyone had a fire go completely out do to the lack of air, just wondering.

thanks, this is for spare parts to have on hand when it quits working sometime about 3:30am about 10deg and on a sunday when everyone is closed. thanks ,jim

blower moter does anyone have the granger part no. for the blower motor assy. for the shaver 165.

my hot tub holds it's heat pretty well and the water heater from the owb recovers it pretty fast. my runs run 24/7 especially for the hot tub because of the daily cycles it goes through , the delay of hot water would not work well.i use a 1 deg. deff.on my stat.

wood useage this is my first year heating with a shaver 165. started it up last week of sept., as of now i have used about 2 3/4 of wood. i am heating my house and attached garage at 72deg.24/7,about 2500sq.ft. also my hot tub and hot water. i did the blower , and ranco digital temp control and...

blower modifacation to the ones that use a modified flaper door on the (shaver 165) blower, are you running your blower full blast or are you restricting your air flow some. i did change the theromosat ( that helped a lot) set at 155 off at 160. with the blower running wide open the recover...