Search results

12' is going to be too short for a compact tractor. It will fit with loader, but no bucket, and nothing on 3 point. Do yourself a favor and get one where the ramps store in the rear, underneath.

That era of truck 2wd were low in the front, especially with a diesel. It has coil springs with "I" beams for suspension in the front. That truck will take the weight

With the gooseneck the truck will carry the load much better. Do yourself with what ever you end up with, get a wireless remote. They should be standard issue. I use to borrow a friends 12' 14k bumper pull dump, Becks Legend trailer, 2 ton empty, add 6 ton stone, not even full bed. It was a wild...

I purchased a Load Trail this summer. 16' 21k gooseneck. triple axle. The reason for the triple axle is that it is very easy to overload tandems. The tongue weight with a tandem will be more than expected with a load, so using a weight distribution hitch would be a wise decision. You will hear...

I had one on a JD 4310 "32 hp". It didn't perform well. The plow is so far out in front of the machine that it pushes the front of the tractor around. A push box is much better for this size tractor. Straight push is no problem and you can push up big piles with the box, get one with the plate...

owning both a 2000 F250 7.3l 6 speed manual bought new and a 2017 f350 dually 6.7l. let me start by saying there is no comparison. the new truck is far better, no comparison. the auto is awesome, you cannot do a better job shifting a manual. the new has two auto modes and a manual mode and you...

Bought this the other day, the trailer 16' 21k gross. Red oak from free craigslist add. Cut up at the curb, just had to load it

Second the grapple. What about a mulch bucket with a grapple?

start with the circulation pumps

if you are wanting to run a 25" bar ms461 is what you need.

Sorry missed the second pipe behind it. what about the circulation pump?

open the valve above the 8" long galvanized pipe on the water heater on the left

the 036 is one of the best power to weight ratio saws ever made. Price is good and the best choice of the options you have given. 18"-20" bar is perfect

you have air pockets in your system, that is why the heat is inconsistent. Run hot in the bottom of heat exchanger and have a way to vent trapped air at the highest point in your system

If it is the pump, all thats needs to be replaced is the cartridge, not the entire pump

Sounds like circulation pump on stove is not moving water. Close valves next to outside pump, unplug electric, remove motor housing, I think the bolts are 7/16" head. Check impeller for breakage/blockage. You can't hurt anything in there. If impeller is broke you can get a "cartridge" for pump...

Check the fuse if the d.r.o. isn't working. Its above the circulation pump, glass type fuse

those flanges are only retained by a small snap ring in the splines, they are held in by the drive axles. i don't think it will work how you want it to.

Thanks Dan.

I don't post much, but here you go.