davidtown
ArboristSite Operative
McCulloch Super Pro 125
Asking $1,800 or best offer
Location: Bend, Oregon 97703
Good condition and runs well. Steel cylinder (not aluminum with chrome lining) The short block was rebuilt by Terry Ives Industries out of California. Terry is a master McCulloch engine builder who mainly works on vintage Kart racing engines but does a lot of saw engines. He replaced the engine seals, cirlips, set of rings, rod bolts, gasket set and reeds (Picture of the receipt below). He also cleaned the engine and set the timing.
Some of the cooler points of the saw are that it comes with the SDC-20 carburetor which is the adjustable carb and not the fixed jet, a fully intact muffler cover and is a local saw to Central Oregon. I purchased the saw in complete condition and isn't pieced together by me. I’m including a 30’’ sprocket nose bar with a .404 chisel chain in great condition. However, if you need a larger bar I have a 41’’ roller nose bar and a new chain which comes with a spare roller nose all at an extra cost. I can only send the saw with one bar...I need the other for a different saw.
I'm located in Central Oregon and will ship. This is a pretty heavy saw and a long bar. I'd assume East Coast shipping to be at least $75-100 in two separate packages but I can find an exact number for interested people.
Dave
Asking $1,800 or best offer
Location: Bend, Oregon 97703
Good condition and runs well. Steel cylinder (not aluminum with chrome lining) The short block was rebuilt by Terry Ives Industries out of California. Terry is a master McCulloch engine builder who mainly works on vintage Kart racing engines but does a lot of saw engines. He replaced the engine seals, cirlips, set of rings, rod bolts, gasket set and reeds (Picture of the receipt below). He also cleaned the engine and set the timing.
Some of the cooler points of the saw are that it comes with the SDC-20 carburetor which is the adjustable carb and not the fixed jet, a fully intact muffler cover and is a local saw to Central Oregon. I purchased the saw in complete condition and isn't pieced together by me. I’m including a 30’’ sprocket nose bar with a .404 chisel chain in great condition. However, if you need a larger bar I have a 41’’ roller nose bar and a new chain which comes with a spare roller nose all at an extra cost. I can only send the saw with one bar...I need the other for a different saw.
I'm located in Central Oregon and will ship. This is a pretty heavy saw and a long bar. I'd assume East Coast shipping to be at least $75-100 in two separate packages but I can find an exact number for interested people.
Dave
