dolkita

Hey friends, couple questions regarding the mentioned saw. Can i upgrade it to .325 ? How well does this saw respond to a muffler mod? I would most likely enlarge the existing outlet but not quite sure how much. What would be the meanest chain for that saw in 3/8 lp pitch? At some point this...

Just had to have these spikes for my 7901 but they are huge!! Do they make bucking harder or is it something a guy will get used to?

Since upgrading my 6401 to 7901 I wanted to try out an 8-pin sprocket to take advantage of some of that extra power. I bought the appropriate Oregon 22273 rim sprocket to give it a try. Everything fits just fine except that the chain now hits the rubber chip guide/deflector. Looking at the...

Everything is gone. Thanks gentlemen. I have two brand new Oregon Power Match 24" bars. This is Oregon's BEST bar and features a replaceable tip. They have the D009 (large Husky) bar mounting holes. Fits just about every Husqvarna / Jonsered / Dolmar / Makita larger than 60cc. They are 24"...

I'm looking for a Makita crankshaft to finish my build. The clutch drum bearing wore into the shaft and created excess play. I don't think I can get away with repairing it thus the search for a used crankshaft. Let me know what ya'll got. Any of the crankshaft's should work from that series, as...

I'm pretty new here, but I've been watching the threads for a while now to try and buy a large milling saw to replace my makita 6401 with BBK that the dealer says needs new bearings now, but haven't found the right one in my price range (those 6401's can be quite the deal). I'm looking for...