Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Aftermarket Cylinder... good and bad... the Truth!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="cowroy" data-source="post: 4129053" data-attributes="member: 60668"><p>I just went back and looked at the comparison Blsnelling did with the 046 comparing stock to untouched Meteor and the difference was .41 seconds. Now I don't know about anyone else but the last thing I am worried about when I cut wood is less than a half a second per cut. Walks like a duck, quacks like a duck :msp_rolleyes:. It would be awesome if they would come out with kits for the Poulan 3700, 4000, 5200 series saws.</p></blockquote><p></p>
[QUOTE="cowroy, post: 4129053, member: 60668"] I just went back and looked at the comparison Blsnelling did with the 046 comparing stock to untouched Meteor and the difference was .41 seconds. Now I don't know about anyone else but the last thing I am worried about when I cut wood is less than a half a second per cut. Walks like a duck, quacks like a duck :msp_rolleyes:. It would be awesome if they would come out with kits for the Poulan 3700, 4000, 5200 series saws. [/QUOTE]
Insert quotes…
Verification
Post reply
Top