Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Changing an 028 to electronic ignition from pts.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Bruce Hopf" data-source="post: 1056414" data-attributes="member: 24036"><p>I use those Modules , I call them computer chips, with my McCullochs all the time. Did he ground the thing properly, and did he soldier the end that connects to magneto. The gap between the flywheel magnets, should be 0.008" to 0.012". Check to make sure. </p><p>I always solder my connections, and never had this problem. I installed one in a Homelite once, and had that problem too. I soldered the connections, and that eliminated it.</p></blockquote><p></p>
[QUOTE="Bruce Hopf, post: 1056414, member: 24036"] I use those Modules , I call them computer chips, with my McCullochs all the time. Did he ground the thing properly, and did he soldier the end that connects to magneto. The gap between the flywheel magnets, should be 0.008" to 0.012". Check to make sure. I always solder my connections, and never had this problem. I installed one in a Homelite once, and had that problem too. I soldered the connections, and that eliminated it. [/QUOTE]
Insert quotes…
Verification
Post reply
Top