Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Firewood, Heating and Wood Burning Equipment
Converted Log Splitter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="cantoo" data-source="post: 2581346" data-attributes="member: 1808"><p>I wouldn't worry about the shaft and 1/16" bend. I bent my loader tractor curl cyclinder almost 3" and it never leaked. I straightened it several times until I had time to replace it. I would think that just your main beam wasn't strong enough. I build alot of stuff and usually I overbuild everything because I'm a little hard on stuff and I hate to take the time to do it twice. Of cost it is possible to build it too strong and waste money too but the beam is a key component so make her big.</p></blockquote><p></p>
[QUOTE="cantoo, post: 2581346, member: 1808"] I wouldn't worry about the shaft and 1/16" bend. I bent my loader tractor curl cyclinder almost 3" and it never leaked. I straightened it several times until I had time to replace it. I would think that just your main beam wasn't strong enough. I build alot of stuff and usually I overbuild everything because I'm a little hard on stuff and I hate to take the time to do it twice. Of cost it is possible to build it too strong and waste money too but the beam is a key component so make her big. [/QUOTE]
Insert quotes…
Verification
Post reply
Top