Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Crank Bearing Removal (PIC HEAVY)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Chris-PA" data-source="post: 5245479" data-attributes="member: 67290"><p>An interference fit means that with both parts at the same temperature the ID is too small to fit over the OD, or any other mechanical fitment with a negative clearance. If you have to change the temperature of one part relative to the other to make them fit together (or use a press), then it is an interference fit.</p></blockquote><p></p>
[QUOTE="Chris-PA, post: 5245479, member: 67290"] An interference fit means that with both parts at the same temperature the ID is too small to fit over the OD, or any other mechanical fitment with a negative clearance. If you have to change the temperature of one part relative to the other to make them fit together (or use a press), then it is an interference fit. [/QUOTE]
Insert quotes…
Verification
Post reply
Top