Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
D196 bar on saw spec for D176?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Modifiedmark" data-source="post: 7779236" data-attributes="member: 18995"><p>Yes you can use that bar as long as you use some 5/16 to 3/8 spacers on the bar studs. As you see the tail is the exact same size and the oil hole is in the same location. </p><p></p><p>You can go to your local hardware store and buy a extension spring that measures 5/16 ID and 3/8 OD for like a buck, then just clip a few coils off about the width of you bar and slide them on your bar studs.</p></blockquote><p></p>
[QUOTE="Modifiedmark, post: 7779236, member: 18995"] Yes you can use that bar as long as you use some 5/16 to 3/8 spacers on the bar studs. As you see the tail is the exact same size and the oil hole is in the same location. You can go to your local hardware store and buy a extension spring that measures 5/16 ID and 3/8 OD for like a buck, then just clip a few coils off about the width of you bar and slide them on your bar studs. [/QUOTE]
Insert quotes…
Verification
Post reply
Top