Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Dolmar/makita/Solo won't start after hot. Please help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lenbates" data-source="post: 8099998" data-attributes="member: 176901"><p>Hey, I'm going to try the 1/4" hole vent, after replacing my vent and still having the fuel gradually starve. It settles down and runs fine again if I set it down and open the tank a bit, so I don't think adjusting the carb is the answer. Can that second vent you mention be installed in the cap? A lot cheaper to replace if it goes wrong somehow.</p><p>Thanks,</p><p>Len Bates</p></blockquote><p></p>
[QUOTE="lenbates, post: 8099998, member: 176901"] Hey, I'm going to try the 1/4" hole vent, after replacing my vent and still having the fuel gradually starve. It settles down and runs fine again if I set it down and open the tank a bit, so I don't think adjusting the carb is the answer. Can that second vent you mention be installed in the cap? A lot cheaper to replace if it goes wrong somehow. Thanks, Len Bates [/QUOTE]
Insert quotes…
Verification
Post reply
Top