Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Easy dolmar 5100/5105/510/460 muffler mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Hedgerow" data-source="post: 5236517" data-attributes="member: 59373"><p></p><p>Hold it wide open on the bench and richen it up till you can audibly tell she's dropping rpms.</p><p>Then lean it back up to the level where it started to drop, defaulting to the "rich" side. Make sure saw is at full "Heat" before setting. </p><p>Cause they'll get a tick leaner as they heat up in a work environment. Just like the 9010's do.. </p><p>Shaun could probably explain why better than me.</p></blockquote><p></p>
[QUOTE="Hedgerow, post: 5236517, member: 59373"] [COLOR=#ff0000][/COLOR] Hold it wide open on the bench and richen it up till you can audibly tell she's dropping rpms. Then lean it back up to the level where it started to drop, defaulting to the "rich" side. Make sure saw is at full "Heat" before setting. Cause they'll get a tick leaner as they heat up in a work environment. Just like the 9010's do.. Shaun could probably explain why better than me. [/QUOTE]
Insert quotes…
Verification
Post reply
Top