Edelbrock 650 -vs- Holley 650 carburetors??

[Fred482]

Sorry guys, I wish I'd have paid a bit more attention to this post. I just sold a Carter "Strip Kit" on evil-bay. It was complete with all the different jets, metering rods and two new (unopened) sets of needle/seats. It would have been a nice addition for one of us here.

I've listed and sold a bunch of stuff that has been collecting dust in the shop. I'll try and keep my eyes & ears open here, if something comes up that I may have a solution for, I'll send a PM before listing it.

 

[NYH1]

Been a while since I've been on the site. I had another TH350 built and went with a 11" Coan 2600 stall converter. This set up is great for what I'm going to use the car for. The little 385 stroker, 2600 stall converter, 3.42 posi with 27" tall tire is an absolute torque monster. It pulls off idle to 56/5800 RPM. Just what I was looking for!