Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Milling & Saw Mills
Engineering data for large timber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Mike Van" data-source="post: 5702496" data-attributes="member: 18615"><p>Forgot to add - The headers are made up of 8, 10, 12 ft oak 2x12s, staggered so the ends are at least 2 ft apart. Good oak too, no big black knots. The building inspector wanted the inner & outer on the 18 ft span to be full length, that was all he asked for so I did it. Making 18 ft 2 x 12's on a mill that only does 16 ft 6 was a challenge best done then, when I was 40.</p></blockquote><p></p>
[QUOTE="Mike Van, post: 5702496, member: 18615"] Forgot to add - The headers are made up of 8, 10, 12 ft oak 2x12s, staggered so the ends are at least 2 ft apart. Good oak too, no big black knots. The building inspector wanted the inner & outer on the 18 ft span to be full length, that was all he asked for so I did it. Making 18 ft 2 x 12's on a mill that only does 16 ft 6 was a challenge best done then, when I was 40. [/QUOTE]
Insert quotes…
Verification
Post reply
Top